62 - Test Tools

Audio test tools you will always need!

#6210 Audio Test Set

Audio Distortion Test Set. Can be used to test the performance of the Orville or another piece of EQuipment connected between input and output.

Effect Type

Suggested Use

Max Sample Rate

In/Out

{F}

[S]

96kHz

4, 4

#6211 Click Test

This preset is a test for clicks or pops in the various audio paths. It works by sending a known signal to its output and then comparing the signals at its input. Depending on the routing,it can be used for internal paths only,or, with the use of external criss-cross connectors, the digital I/O can also be tested. Testing analog I/O is not supported.

Effect Type

Suggested Use

Max Sample Rate

In/Out

{F}

[F]

96kHz

4, 4

#6212 Dig Sig Gen 4

Full blown oscillator with modulation.

Effect Type

Suggested Use

Max Sample Rate

In/Out

{F}

[F]

96kHz

2, 2

#6214 Phase Test

This preset drives all four outputs with an oscillator, and then compares the (assumed looped-back) inputs against each other. This will detect any inter-channel phase or gain errors, as well as any clicks. Due to the precision of the comparison, it is unlikely to be useful with analog signals.

Effect Type

Suggested Use

Max Sample Rate

In/Out

{F}

[F]

96kHz

4, 4

#6216 Oscillator 1k 0vu

General-purpose oscillator. On loading it is set to a 1 KHz sine wave. Lfo (fm) allows addition of an offset and modulation. Output will clipabove +12dB. Aliasing will be audible on triangular and square waves at higher frequencies.

Effect Type

Suggested Use

Max Sample Rate

In/Out

{F}

[S]

96kHz

2, 4

#6217 20>20 Audio Sweep

A general-purpose oscillator. On loading it is set to a 20>20 kHz sweeping sine wave. The output will clip above +12dB. Aliasing will be audible on triangular and square waves at higher frequencies.

Effect Type

Suggested Use

Max Sample Rate

In/Out

{F}

[M]

96kHz

2, 4